IEC Contactors and Starters Frequently Asked Questions
IEC Contactors and Starters Frequently Asked Questions
| Question | My Cutler Hammer starter always resets itself after a trip, how can I make it reset in manual only? |
| Answer | The dial on the overload unit should be moved to the “M” position. The two positions are “M” for manual and “A” for automatic trip release/reset. |
FAQ Subcategory:
This item was last updated on 02-18-2004
Document ID: 841
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.