« Return to the list of questions

Question

How can I enable Counter data types in Think & Do?

Answer

They are not enabled by default. You can "turn on" the COUNTER data type, which is 16-bit unsigned integers by;

Go to ProjectCenter->Project->Settings->Enable Counter data type).
You would then use the standard WinPLC to Modbus register mapping, as documented in the online knowledgebase.

---

FAQ Subcategory: None

This item was last updated on 2012-05-15
Document ID: 1410

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.