WinPLC Frequently Asked Questions
WinPLC Frequently Asked Questions
| Question | How can I set the IP address in my WinPLC with Windows Vista? |
| Answer | Windows Vista does not support the IPX protocol. You cannot use IPX to reset the address. There is a workaround. 1. Insure that you have turned off your PC's firewalls 2. Power down the rack containing the WinPLC. 3. Remove the WinPLC and set dipswitch #7 (last to left) ON 4. Place the WinPLC back in the rack and apply power. The RUN and POWER LEDs will be flashing. 5. Use Netedit3 and scan network using TCP/IP 6. Double click on the WinPLC and change the IP address. 7. Power down the rack containing the WinPLC. 8. Return dipswitch #7 to OFF. 9. Place WinPLC back in the rack and apply power. The RUN and POWER LEDs will not be flashing. |
FAQ Subcategory: None
This item was last updated on 03-18-2009
Document ID: 1067
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.