Question

I cant get the knockouts out of the bottom of the SJ300 drive or the NEMA 1 cover on the L100/SJ100?

Answer

A suggestion would be to drill a self-tapping screw into the knockout and use a pair of diagonal cutters as a lever.

---

FAQ Subcategory: None

This item was last updated on 2001-09-25
Document ID: 868

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.