Question

What is the screw size that fits the jumper hole in the DN-T12 block?

Answer

The older DN-T12 terminal blocks used a M2.6 x 0.45mm screw.

The newer DN-T12-A use a press-in jumper bar.

---

FAQ Subcategory: None

This item was last updated on 2021-02-10
Document ID: 455

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.