EZTouch Panels Frequently Asked Questions
Question
I am unable to communicate with the EZTouch panel from my Programming Computer, what are some things that I can check to ensure that I have a proper set-up?
Answer
- Check cable, ensure that it is the correct cable and that it is properly
connected at both ends.
- Check panel for power.
- Check to ensure the correct PC COM port is selected in the EZTouch Programming Software and that it is available in the PC.
- Check the COM1 setting in Setup Mode on the panel. This info. can be found on page 24 of the Hardware Manual. manual).
FAQ Subcategory: None
This item was last updated on 2009-10-02
Document ID: 450
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.