Question

Why am I getting an E206 from my F2-CP128?

Answer

If you inserted the module into a powered up system, you can can cause this problem. The DL205 system is not hot swappable, you have to remove power to the base before inserting or removing any modules.

---

FAQ Subcategory: Specialty Modules

This item was last updated on 2021-01-25
Document ID: 323

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.