Question

When does the DV-1000 read its setup parameters from the PLC?

Answer

These are read one time just after powerup, and any time a mode change is requested from the keypad.

---

FAQ Subcategory: None

This item was last updated on 2000-10-17
Document ID: 203

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.