Question

What address should I set my module to when connected directly to my PLC?

Answer

If you are referring to the dip switch setting that is found on the backside of the module, and number except 31 will work. It is only important to have a specific module address when connected to the PLC via the OP-9001.

---

FAQ Subcategory: None

This item was last updated on 2000-10-17
Document ID: 179

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.