Question

How do I loop Ramp/Soak patterns in a Solo controller?

Answer

If you need a total of 11 Steps, for example, you need to enter all the Steps for Pattern 0 ( 8 steps), and then the first 3 Steps of Pattern 1.
PSY0 for Pattern 1 will be set to "7" ( 0-based, so all 8 Steps run).
Then set CYC0 to "0" ( no repeat of this pattern).
Then set Lcn0 to "1", (this is the pattern that will be started after the completion of Pattern 0).

Set PSY1 to "2", so the first 3 Steps of Pattern 1 will be run (remember, 0 based, so it's Steps 10-12).
Set CYC1 to "0", so there is no repeat of this pattern.
Set Lcn1 to "0", so that it goes back and runs Pattern 0 again.

The Solo will continuously run this 11 Step pattern while power is applied.

---

FAQ Subcategory: None

This item was last updated on 2015-03-23
Document ID: 1532

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.