Question

The D0-DCM module TX1 and TX2 LEDs are flashing simultaneously. What does that mean?

Answer

The D0-DCM flashes both TX LEDs to indicate it is in Firmware Update mode.

You must complete the FW update using the Koyo Support Tool and the Correct FW binary file. Koyo Support Tool and DCM Firmware file

---

FAQ Subcategory: None

This item was last updated on 2022-09-01
Document ID: 1521

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.