Question

What are the mounting dimensions for the SD1 and SD2 series disconnects when using the shafts and handles?

Answer

The shaft will insert into the handle 16mm min to 18mm max.

The shaft will insert into the SD1 or SD2 10mm.



Measure the distance from the face of the SD1 or SD2 where the shaft will insert to the end of the disconnect handle where the shaft will be inserted and add 26 to 28 mm for the total shaft length.

---

FAQ Subcategory: None

This item was last updated on 2013-11-22
Document ID: 1495

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.