Question

What hardware/software is needed to control the messages on the ViewMarq display?

Answer

The displays are slave devices designed to be controlled by logic controllers that can send ASCII or Modbus RTU strings via an Ethernet or serial connection. However, any devices which support these protocols can send command strings to the ViewMarq display.

---

FAQ Subcategory: None

This item was last updated on 08-01-2013
Document ID: 1449

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.