Question

How do I setup the Ethernet port of the H2-DM1E to use DMLogger?

Answer

Go to Project Browser>Tools>System Info. On the General Information tab, click on the "Set Node and IP Configuration" button. Here, setup a compatible IP address and subnet for your computer, and hit "Ok". This will update your Ethernet port.

Now, you are ready to use the STREAMOUT instruction. Set the "Device" entry to @DMLogger,and fill out the remainder of the instruction as desired. Remember you have to write the project to the CPU.
Open Do-More Logger from the Windows Start menu. Now you are ready to trigger your STREAMOUT and DMLogger will capture it.

---

FAQ Subcategory: None

This item was last updated on 2012-11-29
Document ID: 1434

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.