Productivity Series Frequently Asked Questions
Question
How do I read my P3 system configuration from the software? My "Hardware Config" button is grayed out?
Answer
The CPU must be in STOP mode. You can do this thru the software, or by moving the Run/Stop switch on the CPU to "Stop".FAQ Subcategory: None
This item was last updated on 2012-04-27
Document ID: 1405
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.