SureServo Drives and Motors Frequently Asked Questions
Question
What is minimum bend radius for the cables?
Answer
Unless specified elsewhere the rule of thumb is to not exceed a bend radius of less than 10 times the diameter of the cable.FAQ Subcategory: None
This item was last updated on 2010-09-23
Document ID: 1342
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.