Question

If I use an alarm module on my Eaton Cutler Hammer stacklight which wiring terminal does the alarm module use?

Answer

The alarm module, since it is always the topmost unit on the stacklight, uses the next highest terminal, after the last light module.


For example;

If you had 2 light modules and an alarm module

the bottom light module would use terminal 1

the next light module would use terminal 2

the alarm module would use terminal 3



If you had 1 light module and an alarm module

the light would use terminal 1

the alarm module would use terminal 2.

---

FAQ Subcategory: None

This item was last updated on 2012-04-05
Document ID: 1206

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.