Question

Do you have a cable to connect my GS2 drive to my DirectLogic or Click PLC?

Answer

Yes

For one GS2 drive ONLY, you can use the GS-RJ12-CBL-2 to connect to the 2nd port of a DL05 or Click PLC. The slider switches on the GS2 need to be in the RS232 positions.



For 2or more Drives, from one 06 or 260 you can use
GS-485HD15-CBL-2 to any port on the ZL-CDM-RJ12X4 or ZL-CDM-RJ12x10, then plug GS-485RJ12-CBL-2 cables into the drives and any remaining port on the CDM module. The slider switches need to be in the RS485 positions.

---

FAQ Subcategory: None

This item was last updated on 2016-04-29
Document ID: 1191

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.