Question

Do the PS-series power supplies have a voltage adjustment pot? If so, where is it located?

Answer

The PS-series have a small pot that is located approx. 0.5" under the grill frame of the units. There is no separate hole, you will need to look at the unit from the top to see it. It is located to the left of the DC output terminals.

---

FAQ Subcategory: None

This item was last updated on 2009-03-24
Document ID: 1184

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.