Question

I am not able to force IO bits online. What am I doing wrong?

Answer

a. Check the link setup and verify your link is configured for K-sequence. If it was configured for DirectNet, you will not be able to force bits. If you are using a link with an ECOM module, make sure you check the protocol selected for the link is ECOM.

---

FAQ Subcategory: Communications

This item was last updated on 2009-03-12
Document ID: 1168

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.