Question

I get Error 2225 on my Direct Touch screen. It has been working for years without problem no recent modifications have been made. What could be the problem?

Answer

If your using a DirectLogic PLC the mode switch is more than likely in the "RUN" position with any HMI connected the mode switch must remain in the "TERM" position at all times.

---

FAQ Subcategory: None

This item was last updated on 2008-08-22
Document ID: 1094

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.