Question

I am having trouble getting the IP address of my WinPLC set up, is there an easy way to do this? Not using Windows Vista

Answer

The latest Netedit3 software can be used to assign IP addresses to WinPLCs.
You just need to be locally connected to the WinPLC, open Netedit, and select the IPX option.
Then change the IP address of the WinPLC to an appropriate address for your network.



NOTE!
This will not work if using Windows Vista.

Vista does not support the IPX protocol.

---

FAQ Subcategory: CPU & Programming

This item was last updated on 2009-09-22
Document ID: 1058

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.