Question

Why can I successfully connect with DirectSOFT to a D3-330 with my DCU, but when I put my DCU on a D3-330P, I cannot connect?

Answer

To connect to a D3-330P, dipswitch 6, block 1 (PGM mode at power up) has to be ON.

---

FAQ Subcategory: Communications

This item was last updated on 2001-11-07
Document ID: 102

---

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.