DL06 Frequently Asked Questions
DL06 Frequently Asked Questions
| Question | To connect a modem with a DL06, do I need to jump RTS and CTS on the PLC side? |
| Answer | It is case by case. If your modem does not have RTS/CTS control, you need to jumper RTS and CTS on the PLC side. If your modem has RTS/CTS control, you may connect each signal to the modem. Usually, you would jumper RTS/CTS on the PLC side and the modem side and not be concerned about handshaking. |
FAQ Subcategory:
This item was last updated on 02-19-2004
Document ID: 993
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.