Process Control Frequently Asked Questions
Process Control Frequently Asked Questions
| Question | When I press and hold the "setup" key on the PC35 to configure the controller, the display flashes between settings. Why does it flash? |
| Answer | The "setup" key must be used in conjunction with the "back" key. This allows the user to step through all of the cycles. The flashing is an indication that an illegal operation has been performed. |
FAQ Subcategory:
This item was last updated on 06-05-2002
Document ID: 923
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.