Process Control Frequently Asked Questions
Process Control Frequently Asked Questions
| Question | How do I change from F to C degrees? |
| Answer | PM24 and TC33 – cycle 3 and unit PC35 – cycle 5 and unit. Solo: If the input type is a thermocouple or RTD, the TPUN parameter lets you select either F or C. |
FAQ Subcategory:
This item was last updated on 09-20-2007
Document ID: 919
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.