Process Control Frequently Asked Questions
Process Control Frequently Asked Questions
| Question | Can the units communicate to external devices? |
| Answer | The PM/TC/PC controllers don't have any communication capability. The Solo controllers can communicate via RS-485 Modbus RTU or Modbus ASCII protocol as Modbus slaves. We offer free software to use with these controllers to monitor or set them up via a PC, but you will have to convert the RS-485 signal to something your PC can use (typically RS-232). |
FAQ Subcategory:
This item was last updated on 09-20-2007
Document ID: 917
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.