DirectSOFT Frequently Asked Questions
DirectSOFT Frequently Asked Questions
| Question | The software installed but did not create a link. What do I do? |
| Answer | Locate the DS300.ini file in the Windows directory. Find [devasync.dll] and set all except the current comm port in use =0. i.e. If comm1 is being used to connect the PC to PLC it should look like this : [devasync.dll] COM1Enable=1 COM2Enable=0 COM3Enable=0 COM4Enable=0 COM4=4,3,2,0,0 } COM3=4,3,2,0,0 } these settings will vary COM2=4,3,2,0,0 } from PC to PC COM1=4,3,3,0,2 } ModemEnable=0 COM8Enable=0 COM7Enable=0 COM6Enable=0 COM5Enable=0 [devether.dll] EthernetEnable=0 Ethernet=3,25,5000,0,0,1,0 |
FAQ Subcategory: None
This item was last updated on 03-21-2001
Document ID: 631
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.