EZTouch Panels Frequently Asked Questions
EZTouch Panels Frequently Asked Questions
| Question | Are the EZ-Touch panels a direct replacement for the Direct Touch Panels? |
| Answer | No, these panels differ in programming software and panel cut-out. If you are replacing a 5.7"(6”) Direct Touch Panel with a 5.7" (6”)EZ-Touch Panel you will have to lengthen the horizontal cut-out dimension about a 1/16”. Use the provided template to drill the mounting screw holes or use DIN clips P/N(EZ-BRK-1). |
FAQ Subcategory:
This item was last updated on 11-13-2001
Document ID: 565
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.