DirectSOFT Frequently Asked Questions
DirectSOFT Frequently Asked Questions
| Question | I upgraded to the new DirectSoft, but I can't get a link to my PLC. |
| Answer | When communicating through F2/FA-UNICON and FA-ISONET in DirectSoft 3.0 it is sometimes necessary to go into the link editor and under Flow Control change NONE to RTS/CTS in order to get the software to create a link. This was not necessary in the 16 bit software. |
FAQ Subcategory: None
This item was last updated on 10-17-2000
Document ID: 241
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.