DV-1000 Frequently Asked Questions
DV-1000 Frequently Asked Questions
| Question | Is there a way to cause the DV-1000 to stay in Bit Control Mode (or any mode that I choose)? |
| Answer | You can set up the DV-1000 to power up in particular modes. However, if the operator presses certain keys on the keypad, this takes the DV-1000 out of its original powerup mode. |
FAQ Subcategory: None
This item was last updated on 10-17-2000
Document ID: 201
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.