DV-1000 Frequently Asked Questions
DV-1000 Frequently Asked Questions
| Question | Can the PLC cause the DV-1000 to always power up in a certain mode? |
| Answer | Yes. The powerup default mode may be selected by using a particular entry in the parameter setup table. See Chapter 3 in the DV-1000 Manual for more on this topic. |
FAQ Subcategory: None
This item was last updated on 10-17-2000
Document ID: 200
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.