OptiMate Panels Frequently Asked Questions
OptiMate Panels Frequently Asked Questions
| Question | When should I switch my termination switch to the 'on' position? |
| Answer | Only when the module is at the end of a cable in a system using RS-422 communications. In all other cases, including downloading, the termination dip switch should be in the 'off' position. |
FAQ Subcategory: None
This item was last updated on 10-17-2000
Document ID: 180
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.