DINnectors Frequently Asked Questions
DINnectors Frequently Asked Questions
| Question | Why would I use the DN-J2CUT and DN-J4CUT tool over diagonal cutters or other cutting pliers to cut the insulated plug in jumpers? |
| Answer | The DN-J2CUT and DN-J4CUT will allow the insulated plug in jumpers to keep there insulation on the cut edges of the jumpers. Diagonal cutters or any other cutting tools will remove the protective insulation on the jumpers. |
FAQ Subcategory:
This item was last updated on 11-06-2009
Document ID: 1271
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.