DL06 Frequently Asked Questions
DL06 Frequently Asked Questions
| Question | I just installed a new module in one of the expansion slots but I cannot see it in Configure I/O, what could cause this? |
| Answer | a. This is most likely the PLC firmware version. You will need to update it. b. Click here for Koyo Support Tool download.. c. Click here for DL06 firmware download. d. Install the Koyo Firmware Update Tool and follow the wizard to update the firmware in your PLC. e. Once updated, check Configure I/O. The module should now be recognized by PLC. |
FAQ Subcategory:
This item was last updated on 03-18-2009
Document ID: 1179
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.