DL05 Frequently Asked Questions
DL05 Frequently Asked Questions
| Question | I just installed a new module in one of the expansion slots but I cannot see it in Configure I/O, what could cause this? |
| Answer | a. The most likely culprit here is the PLC firmware version. You will need to update it. b. Download the Koyo Firmware Update Tool (Click here for Koyo Support Tool). and the firmware binary file (Click here for DL05 firmware). c. Install the Koyo Firmware Update Tool and follow the wizard to update the firmware in your PLC. d. Once updated, check Configure I/O. The module should now be recognized by PLC. |
FAQ Subcategory:
This item was last updated on 03-12-2009
Document ID: 1170
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.