AutomationDirect Logo SureServo Drives and Motors Frequently Asked Questions

« Return to the FAQ index

Question How to jump from digit to digit when using P3-08 and setting FF03?
Answer Purpose is to set FF13 in P3-08. When the drive is powered up, please press the MODE key to go to parameter mode. It will show up P0-00. Press 3 times to go to P4-00. Use the DOWN arrow key to go to P3-08. Press the ENTER key. It will show up the content of P3-08. Let us say that shows 0. Use the UP arrow to go to 3 on the least significant digit. Use the NEXT key to move the cursor to the left. Use the UP arrow to go to 1 on the second least significant digit. Use the NEXT key to move the cursor to the left. Use the UP arrow to go to F on the next left digit. Use the NEXT key to move the cursor to the left. Use the UP arrow to go to F on the next left digit.

FAQ Subcategory:

This item was last updated on 03-05-2009
Document ID: 1158

The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.