WinPLC Frequently Asked Questions
WinPLC Frequently Asked Questions
| Question | Can the WinPLC be a Modbus TCP Server? |
| Answer | Yes but you must have the Modbus TCP enabled inthe WinPLC. 1. Open TnD and select I/O view. 2. Highlight the WinPLC module 3. Select Module Info 4. Set EZ Ethernet (Modbus TCP/IP) Port to Enabled The mapping is listed here; Entivity Mapping |
FAQ Subcategory:
This item was last updated on 06-18-2008
Document ID: 1068
The information provided in the AutomationDirect knowledge base is provided "as is" without warranty of any kind. AutomationDirect disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular purpose. In no event shall AutomationDirect or its suppliers be liable for any damages whatsoever including direct, indirect, incidental, consequential, loss of business profits or special damages, even if AutomationDirect or its suppliers have been advised of the possibility of such damages. Some states do not allow the exclusion of limitation of liability for consequential or incidental damages so the foregoing limitation may not apply.